Schlüter Polyethylene uncoupling and waterproofing mat - 30m x 1m roll (Ditra25)
- Product reference: DITRA30M
- EAN: 4011832135538
- Line:
When it comes to a multi-brand pack, it is then the sum of the PPC of its components.
The Schlüter®-Ditra 25 waterproofing mat is a waterproofing system under tiles (SPEC). It is also used for decoupling and vapour pressure equalisation.
Made of polyethylene, it decouples the tiled floor from its substrate to prevent the transmission of movements that could cause cracks or the detachment of the covering. It is covered with a non-woven fabric on its underside.
see detailed description- Material:Orange
- Manufacturer colouring:Polyethylene
- Length (cm):3000
- Width (cm):100
- New product:Yes
- Weight:18 kg
Features of the Schlüter Polyethylene uncoupling and waterproofing mat - 30m x 1m roll (Ditra25) :
- Product type: waterproofing mat
- Collection: Ditra
- Length: 30 m
- Width: 1 m
- Weight: 18 kg
- Material: polyethylene
- Room/workplace of destination: wet room
- Area of use: interior wall / interior floor
- Function of the product: treatment of cracks
- Surface area in m²: 30
- Compatible with heating and cooling floor: yes
- Compatible with PCBT floor: yes
- Type of substrate: old substrate (renovation) / New substrate
- Type of waterproofing system: SPEC
- Manufactured in the European Union: yes
Product benefits:
- Ensures load distribution and good adhesion of the tile covering to the substrate
- Can be used on floors and walls
- Supports the passage of heavy loads
- Allows the installation of large format tiles - uniform heat distribution
.
Advice for use:
- Use a 3x3 or 4x4 notched spatula
- Take care when laying to ensure that air is expelled during installation and that the mat is well anchored
- Fill the cavities well with adhesive mortar
- When laying over old tiles, any loose tiles must be removed
- Removal of the floor is required if more than 10% of the room is loose
- For outdoor use: tiles must be laid with C2 thin-bed mortar with double bonding (full-bath installation) and with a joint spacing of at least 10 mm (Schlüter®-DILEX-EKSN) every 4 m
When it comes to a multi-brand pack, it is then the sum of the PPC of its components.
(2.53% saving)